SAMLink Control System

SAM® Units & Accessories / Options

SAMLink Control System

SAMLink Control System

Key Features

  • Flexible
  • Energy efficient
  • User-friendly systems

Precise Airflow Control

SAM units are controlled individually or in groups, typically 1-4 units per address. Fan speeds are set and/or adjusted from a console located outside the cleanroom without breaching the integrity of the cleanroom. Three levels of adjustment are possible: by Individual address, per Cleanroom zone, or Globally (all addresses). The number of addresses is almost unlimited. Room or equipment layouts with unique airflow requirements are easy to set and control.

Lower Installation Cost

Installation is seamless and quick. Fewer breaker lines reduce material and electrical contractor costs. Reductions in on-site power distribution wiring lower contractor labor cost. Installation cost is lower as a result of simplified balancing and adjusting capabilities along with reducing the time required at start-up. Reduced certification costs.

Lower Maintenance Costs

Recalibration and balancing of rooms are simplified. Small zone shut-down enables isolated upgrade or maintenance operations to take place without disrupting or affecting the integrity of the cleanroom.

Soft Start Capability

SAMlink Systems with adjustable soft start holds start-up to under 0.8 amperes per 277 Volt SAM unit.

SAMlink Control Systems are designed to control  SAM units from a remote console or panel. Linked individually or in groups, an operator can increase or reduce airflow to a selected area and utilize the set back feature during off-peak hours, resulting in lower operating costs.

Our exclusive state-of-the-art, reasonably priced fan filter control systems utilize our standard 115 volt and 277 volt, motor blower units without using high cost DC motors.

SAMLink Systems

SAMLink Systems

Assembled SAMlink System in CRI Cleanroom

Touchscreen Console Shown (other consoles available)

Touchscreen Console front view

  • HEPA or ULPA Filters with 70mm deep pleated design for increased operating efficiency.
  • Choose either NCR or CRF Style SAM units.
  • Single SAM units per control address is most common.
  • Factory wired junction boxes with integral distribution wiring. Substantially reduces on-site electrical work.

A typical SAMlink Control System consists of an address or groups of addresses with four or more  SAM units per address as shown in the top photo. Each address is controlled by a panel or wall mounted console as shown here.  Each address includes the following components:

  • Choice of 115 or 277 volt AC impeller type motor blower assembly.
  • Control Console, panel or wall mounted.
  • With L.E.D. readout and user friendly control features.
  • Wiring for each group of four (4) SAM units.
  • HEPA or ULPA Filters with 53 mm media pack.

Related products (14)

Related products (14)

SAM® MicroSound GS LI (with Lights)

Roomside Speed Control, Aerosol Port & Static Control

Pilot Light, Power Cord & Prefilter

Grilles & Knife Edge

Final Filters

Duct Collar Adapter

Sheet Rock Adapters & Ceiling Collars

Magnehelic Gauges

MicroSound ECM NCR 4 x 4

SAM® MicroSound GS

SAM® MicroSound NCR

SAM® MicroSound 3S GS

SAM® MicroSound 3S NCR


Clean Rooms International, Inc

4939 Starr St SE
Grand Rapids, MI 49546

Terms and conditions

Contact us

Toll-free: 877–380–1860

Phone: 616–452–8700

Fax: 616–452–2372


Terms and conditions

©2021 Clean Rooms International, Inc